i found that my kernel is not 6.1 or higher as recommended in the checklist uname -a Linux RevPi100299 5.10.152-rt75-v7 #1 SMP PREEMPT_RT Tue, 26 Sep 2023 09:43:32 +0200 armv7l GNU/Linux i have a done a fresh install of the system 2 months ago i have installed this image file from the shop 2024-04-2...

hello, my DIO module stops working randomly and the module starts blinking in red until i reboot my device. i have verified that the bridge connecting DIO and core 3 plus works fine this behaviour happens around once a week can you please help me ? i have attatched a video of the behaviour happening...

hello, i would like to know what is the difference between RevPi AIO module and RevPi MIO module not only in regard to the number of inputs and outputs but also : max voltage supported possibility to receive or output a current variant analog signal wiring method the reading value extraction method ...

hello Dirk,

thank you for taking the time to help me,

Unfortunatly i have already tried to reset my RevPi core3+ device with the buster system image provided in the official shop and the same problem is still occuring.

hello i have the same problem the date is stuck at 12/01/2022 and the time is not right when i set it manually it goes wrong when i reboot the device when executing "timedatectl status" i get a message : Failed to query server: Failed to read RTC: Invalid argument the "timedatectl sho...

hello I have a RevPi core 3+ device and the Ethernet port has stoped working. When i remove the ethernet câble the two leds do not stop blinking and the ifconfig command shows an IP address assigned to eth0. I tried using a new system image but the problem still persists. I would like to know the po...

i would like to know what is the maximum Ethernet cable length that can be used for the rev Pi core 3+

thank you

i solved this problem which was related to the static ip address i chose i initially chose a static ip for port B to be 10.10.20.x/24 after looking for similar problem with raspberry pi i found out that "for security reasons, interfaces that are within a LAN naturally reject network packets tha...

i have a RevPi connect + with 2 Ethernet interfaces i need to connect eth0 (port A on the RevPi, DHCP) to a server where my application is running and eth1 (port B on the RevPi, static ip address) to a local network connected to multiple barcode readers my problem is when i connect both Ethernet sim...

At the moment not as fine as is should be :D You can "sudo apt-get install revpipyload" on your Revolutoin Pi and set the XML-RPC service on. At the new version just run "sudo revpipyload_secure_installation" and say YES to "allow from local network" and YES to "s...