Thank you for the advice, I tried with "ip addr show" command, but the result seems the same: 3: eth1: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000 link/ether c8:3e:a7:01:37:f5 brd ff:ff:ff:ff:ff:ff Eth1 IP configuration seems disappeared...

Goodmorning, I'm trying to set a static IP to eth1 port, setting this configuration inside the "/etc/dhcpcd.conf" file: # Static IP configuration of eth1: interface eth1 static ip_address=192.168.254.20/24 #static ip6_address=fd51:42f8:caae:d92e::ff/64 #static routers=192.168.254.1 #static...

Goodmorning, we have purchased the new RevPI Connect in order to get the functionality of OPC UA Server (as mentioned on the website) with Logi.RTS; following the manual of Logi.RTS we couldn't complete the activation of the service because we cannot find the right file that has to be edited ("...

Thanks for the advice Eduard. Unfortunately this configuration was the one that I did at the first time, but I had the flashing red LED about the supply for the input. I solved using an external power supply of 24 VDC connecting in series the sensor and the Analog Input of the Rev Pi. So now I’ m wo...

Hello, I'm trying to connect a pressure sensor with just 2 wires (https://www.ifm.com/nl/en/product/PT5401) with the AIO card but until now I couldn't find a solution. I've followed the tutorial (https://revolution.kunbus.com/tutorials/pinout-revpi-aio/) but at the moment I don't know how to perform...